This modern waterslide material works similarly to vintage decals. Our decals are printed onto a thin film emulsion that slides off a paper backing when dampened. To apply our decals:

o    Wet a clean soft cloth, then wring it out well. Place the cloth flat (fold it to fit) on a plate or other waterproof surface.

o    Cut around the decal and backing. Allow a little space around the decal to prevent cutting into the design.

o    Lay the decal paper side down on the wet cloth and press down. The water will wick up through the paper backing.

o    In about 60 seconds, test the decal to see if it is loose from the backing. If it is not, give it a little longer on the damp cloth; if it is, proceed to the next step.

o    Using another dampened, wrung out cloth, dampen the surface to which you will be applying the decal for added "slip."

o    Slip the decal off the backing and directly onto the surface where you want to apply it. Use your second damp cloth to gently smooth the decal onto the surface, working all wrinkles and air bubbles to the edge. You can reposition the decal as long as the surface beneath is still wet enough to allow it to slide without ripping.

o    Set the item aside until the decal dries thoroughly. Then seal it if desired with acrylic spray or brush-on coat. Unsealed decals are easier to remove if you change your mind later. Sealed decals are safe to wipe with a damp cloth but will still soak off with immersion, scrubbing or a session in the dishwasher.

These decals cannot be fired. They work well on indoor furniture, walls, glassware and glazed ceramics. They can be decoupaged onto sealed woodenware.